Voltage Frequency Converter Module 0-10V to 0-25KHz PLC Electronic Component

1、The module can control the frequency generated according to the input voltage level 2、According to the level of the input voltage, the frequency of the output will also change in proportion to the relationship. 3、The power supply has anti-reverse function 4、The power indicator is on after power up 5、High quality material can make sure the durability of the productFeatures:1. The module can control the frequency generated according to the input voltage level2. According to the level of the input voltage, the frequency of the output will also change in proportion to the relationship.3. The power supply has anti-reverse function4. The power indicator is on after power up5. High quality material can make sure the durability of the productSpecification:Condition: 100% newItem Type: Voltage Frequency Converter ModuleModel: VF-10V25KHzInput Control Voltage Range: 0-10VDCThe input power supply has a voltage range of 12-30 VDC. It is recommended that the power supply voltage be 15-24 VDC. When the 12V level is input, the power supply cannot be powered by 12VDC, and at least 15VDC or more. At 24 levels, the power supply needs to be powered by 24VDC.Current Requirement of the Power Supply: greater than 30MAMounting Fixed: 4 x M3 screw holesSize: Approx. 4.7 x 4.5 x 1.7cm / 1.9 x 1.8 x 0.7inPackage List:1 x Voltage Frequency Converter ModuleInstructions for Use and Wiring:There is a silk screen mark on the top of the module. It can be wired according to the mark. The meaning of the mark is as follows:0-10V: The analog voltage signal is input to the positive terminal.GND: Common ground, GND.12-30V: Power input positive terminal.GND: power ground wireOC-OUT: signal collector output port (use this output port when equipped with a driver)FREQ-OUT: frequency output port (common frequency output port)Two independent outputs, OC-OUT is NPN and FREQ-OUT is IC output. The common cathode end is used with the negative GND of the power supply. When the common anode wiring is used with the power supply, when the common anode wiring is 13-24V, it is necessary to string a 2.7KR resistor. Common anode wiring, when 12V power supply, to string a 330R resistor.An example of the linear correspondence between voltage and frequency:1V converted to 2500HzConvert 5V to 12.5KHzConvert 10V to 25KHz