1. Work environment 1. Ambient temperature 5-40 degrees 2. Environmental relative humidity: 85% 2. Use, care and precautions 1. Remove the electrode protective cover before testing (the solution in the cover is 3MKCL, if crystals ooze out, it is a normal phenomenon and will not affect the use of the electrode) < p>2. Observe whether the inside of the sensitive blister is completely filled with fluid. If bubbles are found, gently shake the electrode (like a thermometer) to remove the bubbles in the sensitive bulb, otherwise it will affect the accuracy of the test. Calibration and testing of the electrode and the pH meter 1.Connect the PH electrode to the input terminal of the PH instrument and the connection is correct. 2. Carry out the calibration according to the instruction manual of the instrument and the calibration result should be measured. Third, the storage and maintenance of the liquid-filled pH composite electrode p> 1. The electrode uses electrical space. Please clean the electrode with distilled water and put it in a protective bottle. It will be activated by injecting the solution before the next test. 2.If the electrode is not used for a long time, it should be rinsed and the remaining distilled water absorbed.< /p> 3. The sensitive glass bulb on the front of the electrode should not be in contact with hard objects, any damage and scratches will make the electrode invalid. 4. After long-term use of the electrode, the slope and response speed of the electrode may decrease. The measuring end of the electrode can be immersed in 4% HF for 3-5 seconds or solution HCL diluted for 1-2 minutes, then cleaned with distilled water in chlorine Soak in potassium solution (4M) to rejuvenate 5. If there is a substance in the tested container which is easy to contaminate the sensitive bubble or block the liquid junction to passivate the electrode, the response speed will be significantly slower, the slope will be reduced or the reading will be unstable, so you should choose according to the nature of the pollutant.Clean with a suitable solution to renew it. describe: Heating voltage: 5 0.2 V (AC/ DC) Working current: 5-10mA Detectable concentration range: PH0-14 Detection temperature range: 0-80 Response time: 5S Settling time: 60S Component power: 0.5W Operating temperature : -10 50 (nominal temperature 20 ) Humidity: 95% relative humidity (nominal humidity 65% relative humidity) Module size: 42 mm 32 mm 20 mm Output: analog voltage signal output With 4 M3 mounting holes Sold by Bianco FR store