Non-Contact Phase Sequence Detector Indicator Detector Meter LED Display 3 Phase Tester Motor Steering Detection Feature: 1. Non-contact phase rotation tester designs for quick , easy and accurate detection of three phase sequence in motor installation and repair . The non-connection to insulated conductor avoids uncertain and difficult connections to bare high voltage wires. 2. Red LED lamps are used to make the indication visible in dimly lit areas.The direction of phase sequence can be checked easily using the LED lamps, which blink in order. 4. This is a phase detector, designed to perform phase sequence checks and live line checks of a 3-phase circuit using a static induction voltage clip. 4. The static induction voltage clips are used to be able to clip on a cladded wire.It is small with a CAT 600V safety rating. Specification: Operating temperature and humidity: -10 to 40(32 to 104), 80%RH or le ( with no condensation) Storage temperature and humidity: -20 to 60 (-4 to 140), 80%RH or le (with no condensation) Location for use: altitude up to 2000m(6562 feet), indoors Maximum rated voltage to earth: 600V Dielectric strength: 5.4kVrms Power supply: rated supply voltage 1.5VDCx2 Two AA size batteries Maximum rated power: 300mVA Continuous operating time: approx.70 hours(Power ON, Standby state, using R6P manganese battery)*Battery life Auto Power Off(This function can not Be canceled): The power will be turned off automatically if the Instrument remains idle for 15 minutes after the power is turned on. To reset, turn the power on again using the Power ON switch. Cable length: approx.0.7m Dimensions and ma: approx.70Wx75Hx30Dmm(2.76Wx2.95Hx1.18D) Note: 1. Due to the light and screen difference, the item's color may be slightly different from the pictures. 2. Please allow 1-3cm differences due to manual measurement. Package Included: 1x 3 Phase Tester 1x Instructions 1x Pack Bag 1x Pacl box