Lithium Pruning Shears Rechargeable Cordless Garden Trimming Branch Electric Pruner AC100‑240VUS Plug Item Type: Lithium Pruning Shears Cutting Branch Diameter: Approx. 25mm / 1in Opening Size: Approx. 40mm / 1.6in Blade Length: Approx. 50mm / 2in Blade Material: SK5 steel Body Material: Plastic Battery Model: Type: Lithium battery Model: 18650 Capacity: 2000mAh Single Working Time: 2-3 Hours Charging Time: 1-1.5 Hours Working Temperature: -10℃ - 65℃ Pruning Shears Size(LxWxH): Approx. 11 x 7.5 x 29cm / 4.3 x 3 x 11.4in Plastic Box Size(LxWxH): Approx. 31 x 9 x 24cm / 12.2 x 3.5 x 9.4in Start Operation: 1. Open the package and insert the battery pack into the battery pack insertion port of the electric scissors. 2. Turn on the power control switch, and the power indicator will show green. 3. The buzzer will sound once when it is powered on for the first time, and it will be activated by pulling the trigger twice continuously. 4. Normal Cutting: Press the trigger and the blade is closed. When the trigger is released, the blade opens. Blade Closed: Press the trigger continuously and the buzzer will beep for a long time to indicate the blade is closed. 5. Before working, press the trigger intermittently to close the blade without load several times to check whether it is normal. 6. Start to work after normal. Packing Operation: 1. Keep pressing the trigger for more than 5 seconds, release the trigger, and the blade will close and no longer open 2. Turn off the power and remove the battery 3. Organize, clean, and pack Failure Prompt: Number of consecutive buzzers-Fault-Solution 1-Abnormal battery power-Check whether the battery power is too low 2-Abnormal communication-Check whether the cable connectors of each part are loose 3-Abnormal opening-Refuel the blade 4-The motor lacks phase-Send to the local maintenance department for overhaul 5-Short circuit of the motor phase wires-Check whether there is a short circuit in the cable or the connector The buzzer sounds continuously-Safety warning-Check if the body is in contact with the blade. Battery Charging: Main Matters: 1. Before charging, please turn the switch to the off state. It is normal for the charger and battery to slightly heat up during charging 2. If the battery is not used for a long time, in order to extend the applicable life, it must be recharged once every 3 months 3. A new battery or a battery that has not been used for a long time needs about 5 charge and discharge cycles to reach the maximum capacity 4. Do not recharge the battery after only a few minutes of operation, which may reduce battery working time and performance 5. Do not use damaged batteries, and do not disassemble the charger or battery 6. The battery will explode when thrown into the fire, do not grill the battery 7. Do not charge the battery outdoors and in a humid environment 8. With the gradual decrease of battery power, it is normal that the ability to cut the diameter will decrease 9. During the charging process, the electric pruning shears must be disconnected, and it is strictly forbidden e the electric pruning shears while charging Blade Replacement: When the entire length of the movable blade no longer overlaps the fixed blade well, or the cutting is still not clean after sharpening the blade, it is recommended that you replace the blade. The operation steps are as follows: To ensure safety, please turn off the power before replacement and remove the battery. Use a hex wrench to open the bearing and replace the cutter head. After the replacement, clean it, connect the battery, power on the test, close the blade, and complete