This is a DIY thermal repair rhinestone applicator that can make shiny rhinestones for your items. Small size and easy to carry.The non-slip handle design is very user-friendly, giving you a comfortable experience. The ergonomically shaped handle makes it easy to use.Equipped with a safety stand and 7 different applicator tips for applying heat-fixed crystals of different sizes. You have different uses at any time.It only takes 2-3 minutes to warm up and is easy to use. Built-in thermostat, no need to adjust the temperature. With switch, easy to control and operate.Application: Suitable for all flat fabric materials, suitable for most types of crystals/rivets/beads.Product Technical specifications:Material: ABS shellPurpleManual:1. Insert the applicator stick and open it. Keep it for 2 minutes. 2. Put the point with the stone on the stone, and then pick it up.3. Observe the glue until it becomes wet and shiny. Now you can apply the stone to the surface. Depending on the size of the rhinestone, it may take about 5 seconds or more.4. Gently push the applicator at a 90 degree angle to the surface. Move the applicator up and away. If the stone is stuck on the tip, use tweezers to push it down into the groove in the tip to remove the stone.5. If the stone is not properly glued, place the end cap on the stone for a few seconds to melt the glue again.Scope of supply:1 x rhinestone applicator1 x bracket7 x interchangeable precision tips