H743-SLIM V3 BEC ICM42688P Baro OSD F7 Flight Controller 2-8S Lipo 30.5X30.5mm for RC Multirotor FPV Drone FC Specifications MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash :42688P Baro: DPS368 (I2C2) OSD: AT7456E (SPI2) : MicroSD card socket (SDIO) 7x Uarts (1,2,3,4,6,7,8) with built-in inversion. 13x PWM outputs(including "LED" pad) 2x 1x CAN 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) 1x SPI3 breakout USB Type-C(USB2.0) 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4) 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G) Dual Camera Inputs switch 5V/Vbat filtered power ON/OFF switch FPV OSD is supported by any spare UART Power Vbat Input: 6~36V (2~8S LiPo) BEC: 5V 2A cont. (Max.3A) 3.3V: Max.200mA No Current Sensor built-in ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K) Static power: 200mA@5V with Betaflight, 150mA@5V with FC Firmware (ChiBiOS): MATEKH743 BetaFlight: MATEKH743 INAV: MATEKH743 Physical Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm Dimensions: 36 x 36 x 5 mm Weight: 7g Color: As Shown Material: PCB Package Contents: 1set * Flight Control Board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.