Engine Speed Control Unit EG2000 is an universal generator governor / engine speed controller equipped with Smoke Limiting, & Idle Speed. Suitable for , and natural engines with Built-in & Non-Built-in Pumps, also can be used with Low Current, Electric over Hydraulic Oil Pumps Type Governor Actuators. It's compatible with following model. Features of EG2000 Speed Control Unit Works on a wide ranges of MPU/flywheel frequencies 15 Amp Max Output Suitable for all types of and engines. High Sensitivity and stable at Low Frequency Variations. Moisture, vibration, and rust , Epoxy encapsulated electronics. For Use With Isochronous Generators & Automatic Paralleling PLC controls. Idle Speed Adjustment and connections for a Remote Speed POT Specifications for Kutai Engine Control Unit EG2000 Colour: Black : plastic Operating Voltage 10 to 30 Output Current From 0.5 Amp to 15 Amp Frequency Range 600 Hz ~ 9500 Hz ( Signal) Idle Speed Frequency Adjustable From 30~85% of normal Speed Band 0.25% at steady state Temp. Stability Between -40~85 C 0.5% Remote Speed Adjustment Range (2 mode) Adjustable Range 5% with 5 K Ohm potentiometer Ramp Time 3 to 20 Sec. (Adjustable) Operation Environment Operation Temp. : -40~85 C Storage Temp. : -40~85 C Relative Humidity : Maximum 95% Vibration : 3G @ 100~2 KHz DIP Switch SW1 : ON 600~1200 Hz SW2 : ON 1200~2500 Hz SW3 : ON 2500~5000 Hz SW4 : ON 5000~9500 Hz Governor Controls DROOP : Droop Rate Adjustment GAIN : MPU Output Gain Adjustment . : Engine Stability Adjustment RAMP-TIME : Soft Adjustment SPEED : Speed Adjustment IDLE : Idle Speed Adjustment Dimensions 147.0 (L) x 114.0 (W) x 40.0 (H) mm Weight 690g Package Contents: 1 x Engine Speed Controller Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.