1Have speed control function, include voltage speed control or single-chip microcomputer speed control, microcomputer control PWM speed control. 2Made of highquality material PCB, sturdy and durable, have a long service time. 3Possess favorable mechanical characteristics and adjustment characteristics, good linearity, wide speed adjustment range, long life, easy maintenance, low noise 4Brushless Motor Controller's operating efficiency, lowspeed torsion, and speed accuracy of the brushless DC motor are better than those of any control technology inverter. 5Small in size and light in weight, convenient to carry and use at any time, very convenient and practical. Item Type: Brushless Motor ControllerMaterial: PCBPurpose: Brushless motor drive controlWorking Voltage: DC 12V-36VWorking Current: 15ADrive Power: 500WSpeed Voltage: 0.1V-5VWorking Temperature: -40-85Humidity: 90% RhStall Protection: YesEnable Control: YesOvercurrent Protection: YesSteering Control: YesSpeed Control Signal: YesPower Terminal Output:VCC (positive power supply)GND (minus one)MC (Motor Phase W)MB (Motor Phase V)MA (motor phase U) .wang-edit-text{ font-family:'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px 5px; } .wang-edit-text table th { text-align: center; } 1 x Brushless Motor Controller 1. If the heat sink you use is less than 60W and there is no additional heat sink, you must add a heat sink above 60W. If the driving efficiency of the heat sink is not reduced, excessive temperature will cause permanent damage. 2. The size of the radiator may be based on harsh environment work (recommended cooling area is greater than 200 square centimeters). 3. When installing the heat sink, be sure to pay attention to the insulation of the MOS tube on the back of the module. If there is no insulation, it will stick to the drive board and be permanently damaged. 4. It is recommended to add thermal insulation film and thermal grease on both sides.