Feature:1. Edge location: The edge finder is designed to measure edges, holes, studs, angles, corners, etc. With high accuracy. 2. Flexible Applications: Supports online automatic measurement and also acts as an offline acoustic beam splitter in 5 directions. 3. Functions: connect GND and output signal line . After receiving the signal by the main computer, the macro program will realize the functions of automatic centering and coordinate recording. 4. Good material: adopting the highest quality aluminum alloy material, it probably does not deform, and also has high durability for long -term use. 5. Easy to install: Lightweight and compact, the installation of this touch probe is very convenient to do . . Edge Finder 3D Touch Probe Specification: Item Type: 3D Edge Finder Note on parameters Material 7075 Anodized Aluminum Alloy Surfaces Edge Finder Outer Diameter (Approximate) 39mm / 1.54inch Probe length (approximately) 20mm/0.79inch, standard Can be replaced. Mounting diameter (approximately) 6 mm / 0.24 inch Handle length (approximately) Repeatability (approximately) 0.01 mm X and Y Swing axes (approximately) 3 mm / 0.12 inch Exceeding the stroke will cause damage. Z-axis Swing (approximately) 1.5 mm / 0.06 inch Exceeding the stroke will cause damage. Offline operation Yes It can be used as a photoelectric centering rod. Online work Yes It can be used with automatic centering system. Connection method Using the included data cable. 2m / ft , approx. Probe diameter (approximately) 2 mm / 0.08 inch IP43 Waterproof level Cannot work in coolant environment. Operating voltage 6-30 V Burns under pressure and cannot operate under low pressure. . Edge Finder 3D Touch Probe Package List:1 x 3D Edge Finder 1 x Connection Cable 1 x Key 1 x Storage . Edge Finder 3D Touch Probe